In theory, how deep can a natural formation on the surface of the Earth's crust be? What are the limits to this depth?
$\begingroup$
$\endgroup$
5
-
3$\begingroup$ Do you mean the sea floor? Because the inner core is a natural formation and that goes to 6400km deep give or take... $\endgroup$–winwaedApr 16, 2014 at 1:15
-
$\begingroup$ @winwaed I meant something that we 'd be able to descend into, like the Mariana Trench. $\endgroup$–Zoltán SchmidtApr 16, 2014 at 1:17
-
$\begingroup$ @ZoltánSchmidt: "can" kind of implies a theoretical maximum. Like, what is the deepest point thatcould ever formon earth. Do you mean that, or do you just mean "what is the lowest known point on the surface of the earth's crust?" $\endgroup$–naught101Apr 16, 2014 at 8:41
-
$\begingroup$ @naught101 Thepossiblelowest. $\endgroup$–Zoltán SchmidtApr 16, 2014 at 11:36
-
1$\begingroup$ Ok, I re-worded it to make it clearer. Feel free to reject the edit if it's wrong, or use it to clarify your question. (on a side note, would a moon-sized meteorite ploughing through the centre of the earth count as "natural" and "deep"? :P) $\endgroup$–naught101Apr 16, 2014 at 11:43
Add a comment
|
3 Answers
$\begingroup$
$\endgroup$
Challenger Deep (10.99km) in the Mariana's Trench is the deepest part of the ocean floor. This is probably close to the deepest theoretically possible ocean floor with the current thermal regime.
With the current thermal regime, the deepest 'steady state' ocean floor depth is about 5.5-6km (cooling curves at Muller et al) - limit is reached as the ocean crust cools and subsides. The crust (lithosphere) is effectively floating on the mantle (asthenosphere), and this steady state situation is known as 'isostatic equilibrium'.
You can get deeper by moving from a static to a dynamic situation. A subduction zone provides this - the subducting plate is moving and being pushed down, resulting in a deep ocean trench. Eg. The Mariana's, or the trench offshore Chile. A fast subduction zone should go deeper. A deep hole like this will also tend to fill with sediment. The fastest subduction zones move at about 16cm (and these are only the short arcs). The physical characteristics of the ocean crust will also vary a little (thickness, temperature), but beyond these parameters it is difficult to make the hole deeper, as it were.
$\begingroup$
$\endgroup$
2
In theory, a new fissure could open up at any time, leading to a new depth. But for a long while now, the deepest known natural point is theMariana Trench- just shy of 11km deep!
However, we have gone deeper!
In 1970, theKola Superdeep Boreproject had several boreholes drilled from a central hole. The deepest - SG-3, reached 12,262metres into the earth. The goal was to get to 15000m, but the problem is that the drill bits start melting in the heat down there - they need to operate in over 300 degrees Celsius!
-
$\begingroup$ The Kola Bore isn't a natural formation though.How about a meteorite crater? $\endgroup$ Apr 16, 2014 at 12:01
-
$\begingroup$ @naught101 that's why I mentioned the Mariana trench, but figured out of interest it was worth mentioning we have deeper holes. $\endgroup$ Apr 16, 2014 at 14:13
$\begingroup$
$\endgroup$
2
About the limits: The largest depths on land are created by thinning of the lithosphere (Dead Sea rift as far as I know). The limit to this lowering is of course the inflow of the ocean (So the deepest point you can reach on dry land can only be slightly lower than the ocean water level.
In the ocean the deepest points are the places where the subducting plate pulls the lithosphere down into the astenosphere. The longer the attached subducting plate is (before it detaches), the stronger the force will be. It is probably difficult to say how deep a subduction trench can get because as it deepens it is also filled with sediments.
-
$\begingroup$ The becomes a theoretical point where thinning would reach zero thickness crust. However there is a stretch point (~2x iirc) beyond which an ocean ridge forms and it become self sustaining. On the other hand you could argue that 0 thickness crust occurs only at mid ocean ridges - and those are relatively shallow due to isostasy. $\endgroup$ Apr 16, 2014 at 12:42
-
$\begingroup$ Note that there is an ongoing debate on whether the Dead Sea basin is a rift or a transform, or both. A new book was just published on it:springer.com/earth+sciences+and+geography/geophysics/book/…in case you're interested. $\endgroup$ Nov 4, 2014 at 9:45